Rapid-air CUT-TO-LENGTH WITH MULTI-STROKE Instrukcja Użytkownika Pobierz pdf (Strona 34)

Cut to Length with Multi Stroke Program

(Alternating) E5* 229 Control Card hardware not compatible

with drive software version

(Alternating) E6 230 Drive transition from unconfigured to

configured while enabled

(Alternating) E7 231 Two AInNull events too close together

(Alternating) F1 241 Excessive Position Following Error

(Alternating) F3 243 Parameter Checksum Error (Memory Error)

*FaultReset cannot reset these faults.

See ExtFault for further information on Blinking E, Blinking 1 and Alternating F3.

REASSEMBLY OF UNIT

Prior to assembly, attention must be given to three points of contact that

require an application of Moly-Cote, Lubriplate or other suitable heavy grease.

The three points are:

1. The antibackup piston which is located at the feed entrance.

2. The main roll piston and the spiral pins in the main roller tie plate which can

be seen by viewing straight down through the center of the feed at

approximately half way from the inlet to the exit roller. The piston is positioned

horizontally at the base of the feed and approximately in the center of the feed

if viewing from the gear box to the belt cover.

file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (33 of 66) [12/10/2001 3:44:58 PM]

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Brak uwag

Rapid-air CUT-TO-LENGTH WITH MULTI-STROKE Instrukcja Użytkownika Strona 34